Envelope sleeve dieline

Free envelope sleeve dieline template: a slim sleeve for a card or a photo, open at the top and closed by a round flap that tucks into a slit. Enter width and height; get a print-ready PDF.

About this dieline Envelope sleeve dieline template: cut, fold and safe-area lines

About this dieline

An envelope sleeve is a slim card pocket for a gift card, a photo, a ticket or a voucher. The back and the front sit side by side on one fold, a glue flap and a bottom flap close the side and the bottom, and the top stays open. A round flap on the front, a dome with a shoulder on each side, folds over and tucks into a slit in the back, under a small thumb cut.

Enter the width and height of the finished sleeve and download a print-ready PDF at true size with the cut outline, the slit, the folds, the glue zones and the safe area. The flap is a third of the width, and the slit sits where its tip lands, so the flap always reaches it.

How big should the sleeve be for my card?

Add a few millimetres to each side of what goes in. A standard gift card is 85.6 × 54 mm, so a sleeve about 70 mm wide and 105–110 mm tall holds it upright.

Is the top flap glued?

No. Only the side flap and the bottom flap are glued, once, to make the sleeve. The top flap tucks into the slit, so the sleeve opens and closes again.

Card envelope and sleeve sizes: hanging, buckle and sleeve envelopes for cards →