Paper cup dieline
Free paper cup dieline template for single wall hot cups. Enter the cup's top and bottom diameter and height, or pick a ready size; get a print-ready PDF of the curved wall with its print area, rim curl, bottom fold and glue zone.
About this dieline
About this dieline
A paper cup for hot drinks is what a café, a bakery or an event hands over the counter, and printed with your brand it travels with every coffee. Its wall is one curved sheet of board: the slice of a cone that rolls up into the cup, with a separate round bottom that is never printed.
Pick a ready size or enter your cup's top and bottom diameter and its height, as the cup maker lists them. You get a PDF at true size with the curved outline, the edge of the print, the rim curl and the bottom fold, the glue zone at one end and the safe area. The rim curl, bottom fold, glue zone and seam bleed are fields too, and the glue can sit on either end, because every cup maker's die is a little different.
Where should my design go?
Inside the grey print edge, and keep text and logos inside the blue safe area: the top of the print rolls into the rim and the bottom turns under the base. At the seam end the print runs a little past the cut, so a solid colour closes on itself with no board showing. You can also design on a flat rectangle: download the template in the 3D view, upload your design there and see it bent onto the cup.
My cup maker's die looks a little different. Which do I trust?
Your maker's. Each one sets its own rim curl, bottom fold and glue zone, and some put the glue on the other end. Copy those numbers into the fields, pick the glue side, then print one at 1:1 and check it against a real cup before the run.