Size charts
- Stand up pouch sizes
- Coffee bag sizes
- Flat bottom pouch sizes
- Flat pouch sizes
- Pillow pouch sizes
- Stick pack sizes
- Sachet sizes
- T-shirt bag sizes
- Wicket bag sizes
- Die-cut handle bag sizes
- Loop handle bag sizes
- Mailer bag sizes
- Paper bag sizes
- Pinch bottom paper bag sizes
- Baguette bag sizes
- French fry bag sizes
- Mailer box sizes
- Shipping box sizes
- Tuck lid shipping box sizes
- Tab lock mailer sizes
- Tissue box sizes
- Carry handle box sizes
- Shoe box sizes
- Octagon box sizes
- Wine carrier sizes
- Roof box with handle sizes
- Pizza slice box sizes
- Slice tray sizes
- Beer box sizes
- Open tray sizes
- Gift box sizes
- Drawer box sizes
- Cake box sizes
- Display box sizes
- French fries box sizes
- Gable box sizes
- Cake box with handle sizes
- Popcorn box sizes
- Tuck box sizes
- Hang tab box sizes
- Crash lock bottom box sizes
- Snap lock bottom box sizes
- Pillow box sizes
- Pizza box sizes
- Burger box sizes
- Cup sleeve sizes
- Hang tag sizes
- Envelope sizes
- Pocket folder sizes
- Self-locking folder sizes
- Closed folder sizes
Size chartsUpdated
Burger box sizes
A burger box is the clamshell a burger travels in: a base and a hinged lid from one sheet of board. Here are typical sizes, from a slider to a tall stacked burger, so you can start from one that fits.
Size chart by what goes in
| For | Length × width × height | Dieline |
|---|---|---|
| Slider A small burger or a slider |
103 × 107 × 73 mm 4.1 × 4.2 × 2.9 |
Make this dieline → |
| Small burger A single patty |
106 × 106 × 69 mm 4.2 × 4.2 × 2.7 |
Make this dieline → |
| Single burger The everyday cheeseburger |
108 × 108 × 70 mm 4.3 × 4.3 × 2.8 |
Make this dieline → |
| Regular burger A single with salad and sauce |
105 × 105 × 85 mm 4.1 × 4.1 × 3.3 |
Make this dieline → |
| Medium burger A loaded single |
110 × 116 × 86 mm 4.3 × 4.6 × 3.4 |
Make this dieline → |
| Large burger A double patty |
120 × 120 × 85 mm 4.7 × 4.7 × 3.3 |
Make this dieline → |
| Tall burger A stacked burger with a high bun |
111 × 111 × 111 mm 4.4 × 4.4 × 4.4 |
Make this dieline → |
Typical sizes, not a standard: every supplier's list is a little different. Length runs along the hinge, width from front to back, height is the closed box. Your printer will adapt them to your burger.
How to measure
- Length and width: the floor of the base, crease to crease. Take the bun's width and add a few millimetres. The walls lean out, so the box is wider at the seam than at the floor.
- Height: the closed box, half in the base and half in the lid. Measure the burger standing, with its toppings.
Which board?
Most burger boxes are food-safe paperboard of about 0.4–0.6 mm, white or kraft, often with a grease barrier on the inside. Ask your printer which one they stock for hot food.
Serving fries or a drink on the side? Have a look at the cup sleeve sizes.