Skip to content
Dieline Studio
Open the dieline
Size charts

Size chartsUpdated

Shoe box sizes

This shoe box is made from one piece of corrugated board, with the lid hinged on at the back. The end walls roll over at the top and lock the corners, the front of the lid locks with two tabs, and there is a finger notch at each end to lift the lid. No glue or tape: it ships flat and folds by hand.

Typical sizes

What goes inLength × width × heightDieline
Women's shoes 305 × 178 × 102 mm
12.0 × 7.0 × 4.0
Make this dieline →
Men's shoes 330 × 203 × 127 mm
13.0 × 8.0 × 5.0
Make this dieline →
Men's shoes, large 351 × 201 × 119 mm
13.8 × 7.9 × 4.7
Make this dieline →
Slim shoe box 320 × 150 × 100 mm
12.6 × 5.9 × 3.9
Make this dieline →

Sizes that shoe boxes are sold in, not a standard. Shoes differ by brand and size, so measure the pair you pack before you order.

How to measure

  • Length: heel to toe of the longer shoe, plus 10–15 mm for tissue paper.
  • Width: the two shoes side by side, one turned heel to toe, at their widest, plus 5–10 mm.
  • Height: the highest point of the pair, usually the heel or the ankle, plus 5–10 mm. From 70 to 150 mm.

Our sizes are crease to crease. A taller box needs a longer one: the lid's corner locks take room along the front, so the length is at least 150 mm plus two thirds of the height.

Which board?

One-piece shoe boxes are made of corrugated board: E flute, about 1.5 mm, for printed boxes on a shop shelf, and B flute, about 3 mm, for boots and for shipping. The box needs no glue, so fold one by hand with a pair of your shoes inside and lift it by the lid before you order a run.

Related guides

Feedback

A link or a photo of a sample, plus the sizes you need, saves us guessing.

so we can write back