Skip to content
Dieline Studio
Open the dieline
Size charts

Size chartsUpdated

Pyramid top box sizes

A pyramid top box is a square box whose four walls rise into a pointed top, tied at the tip with a ribbon. It folds from one piece of paperboard with one glued seam and a tuck bottom, and makes a favour or a small gift look finished before it is opened.

ForSide × wallsWhole heightDieline
Wedding favour
Sweets or a single chocolate
51 × 32 mm
2.0 × 1.3
64 mm
2.5
Make this dieline →
Party favour
Small gifts, jewellery or a gift card
76 × 41 mm
3.0 × 1.6
88 mm
3.5
Make this dieline →
Soap or candle 102 × 63 mm
4.0 × 2.5
127 mm
5.0
Make this dieline →
Large gift
A bath set or several gifts
127 × 86 mm
5.0 × 3.4
165 mm
6.5
Make this dieline →
Pillar candle
Ø 68 × 90 mm
70 × 92 mm
2.8 × 3.6
136 mm
5.3
Make this dieline →
Christmas bauble
Ø 80 mm, under a tall top
82 × 50 mm
3.2 × 2.0
140 mm
5.5
Make this dieline →

Sizes from a seller of pyramid boxes and from the things that go in, not a standard. Measure what goes in before you order.

How to measure

  • Side: one side of the square box. Make it at least the widest point of what goes in, plus 1–2 mm.
  • Wall height: how tall the straight walls stand, bottom to where the pyramid starts. Everything that is not narrower at the top should fit under it.
  • Top height: how tall the pyramid rises over the walls. Left at automatic, it is about 0.6 of the side.

Our sizes are crease to crease. The whole box stands walls plus top: a 90 mm box with 60 mm walls is about 116 mm tall with the automatic top.

When to make the top taller

The pyramid holds whatever is narrower at the top: the dome of a frosted cupcake, a ball, a bauble with its cap, the neck of a small bottle. Make the top taller than automatic for those, and keep the walls just as tall as the widest part. A taller top also looks more like a gift on a table. It can never be lower than 0.6 of the side: below that the corners cannot fold inside.

Which board?

Pyramid top boxes are usually made from white paperboard about 0.5 mm thick (350 g), which takes the many slanted creases cleanly and prints well. Thinner board, down to about 0.3 mm, suits small favours. Corrugated board is too thick: the corners of the top fold in half inside the box, and that needs thin board.

Related guides

Feedback

A link or a photo of a sample, plus the sizes you need, saves us guessing.

so we can write back